Configuration | Wan | Compression - Comtec CDM-840 Installation And Operation Manual

CDM-840 Remote Router
Ethernet-based Remote Product Management
6.3.3.2.5

Configuration | WAN | Compression

Use this page to configure the Payload and Header Compression feature, if enabled.
Click the (Link to Compression Statistic page) hyperlink to access the Status | Statistics |
Compression page (Sect. 6.3.4.1.3).
Refresh Rates
Enter each refresh rate, from 1 to 600 packets or 1 second (whichever comes first). From left to
right:
Feature
Header Compression for UDP
Header Compression for RTP
Header Compression for all others
Payload Compression
Set the desired rates. Click [Submit] to save.
Bridge Point-to-Multipoint (BPM) Mode Configuration
Use the drop-down lists to Enable or Disable Payload and Header Compression for all of the
transmitted packets when operating in Bridge Point-to-Multipoint (BPM) Mode. Click [Submit]
to save.
In Managed Switch Mode, the selected Compression modes apply to all traffic.
Figure 6-23. Configuration | WAN | Compression Page
Description
User Datagram Protocol refresh rate
Real Time Protocol refresh rate
Default protocol refresh rate
Payload Compression refresh rate
6–49
MN-CDM840
Revision 3