Comtec CDM-840 Installation And Operation Manual page 124

CDM-840 Remote Router
Ethernet-based Remote Product Management
•
Change (modify) an existing group – Use the middle row text boxes to make changes to the
active Index (group). Click [Change] to save. The Group Table will update accordingly.
•
Delete an existing group – Use the bottom row text box to enter an Index (group) number.
Click [Delete]. Upon deletion, the table index automatically decrements to the next
available number.
About the Default Group – This group will always exist and cannot be removed. The Default
(QoS) Group has the following characteristics:
•
The Default Group is always serviced after the CIR and MIR for user-defined QoS groups
have been serviced (i.e., what is left over). The Default Group should not be used to reserve
bandwidth.
• The CIR for the Default Group is forced to 0kbps.
•
The MIR for the Default Group is forced to the Maximum.
•
If a packet does not match one of the user-defined subnets associated with a QoS Group,
the packet will be put into the Default Group.
•
The Default Group contains all of the discovered Remote Sites. This means that if a matching
Subnet is not found for a User-defined QoS Group, the Default (QoS) Group will be used and
Outbound ACM will function as expected.
Group Table
This table displays the active QoS groups. See the table under "Add/Change/Delete Group" for
detailed descriptions for each column. When more than one group is available, click Select to
set that group as the active operational configuration. The page refreshes automatically. If only
a single group exists, the page appearance defaults to display that group in all tables.
Add/Delete Per Group Attribute
When more than one group is created, use the controls in this section to select and configure an
attribute:
6–42
MN-CDM840
Revision 3