Comtec CDM-840 Installation And Operation Manual page 71

CDM-840 Remote Router
Updating Firmware
f) On the PC – Make note of the information displayed on the CDM-840 Serial Interface:
• Management IP Address (default is 192.168.1.12/24)
•
Firmware Number and Revision Letter (e.g., FW-0000408AL)
•
Firmware Release Version (e.g., 1.6.2.4)
g) Alternately, use the CDM-840 HTTP Interface to obtain the firmware information.
•
On the PC – Use a Web browser (e.g., Internet Explorer) to log in to the CDM-840 HTTP
Interface and open the Admin | Firmware page. Then, make note of the Slot #1 and
Slot #2 firmware loads:
2. Create a temporary folder (subdirectory) on the User PC for the firmware archive download.
•
•
The serial and HTTP interface figures as featured throughout this chapter
are intended for user reference only and are subject to change. The
firmware information (i.e., revision letters, version numbers, etc.) as
displayed may differ from your setup.
See Chapter 7. SERIAL-BASED REMOTE PRODUCT MANAGEMENT for
information and instructions on using the CDM-840 Serial Interface.
See Chapter 6. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT for
information and instructions on using the CDM-840 HTTP Interface.
Drive letter "c:" is used in these examples. Any valid, writable drive letter
can be used.
Typical for all tasks: Type the command without quotes, and then press
Enter to execute.
4–3
MN-CDM840
Revision 3