Configuration; Configuration | Interface; Configuration | Interface | Fe Mgt - Comtec CDM-840 Installation And Operation Manual

CDM-840 Remote Router
Ethernet-based Remote Product Management
6.3.3 Configuration Pages
MEO (Medium Earth Orbit) is not available in this firmware release. The MEO tab
and its nested page, while available and selectable on this interface, are therefore
NOT OPERATIONAL.
Use the Configuration pages to configure all unit parameters. Click the Interface, WAN,
Network, ECM, or dSCPC tab to continue.
6.3.3.1 Configuration | Interface Pages
Click the FE Mgt, GE, or E1 tab to continue.
6.3.3.1.1

Configuration | Interface | Fe Mgt

1) The IP Addresses for the FE and GigE Interfaces must be different and on
separate subnets.
2) The 'ETHERNET | MANAGEMENT | FE' port will always be in Router Mode. The
'ETHERNET | TRAFFIC | GE' port will change from Router Mode to BPM Mode
when the Working Mode is changed.
Use this page to configure the rear panel 'ETHERNET | MANAGEMENT | FE' 10/100 Fast
Ethernet M&C port. Note that this port serves as the dedicated Ethernet-based monitor and
control interface between the CDM-840 and the User PC.
FE – Management Interface
The valid operating ranges for items in this section are provided in parentheses.
•
MAC Address (read-only) – Ethernet MAC Addresses are configured at the factory and
cannot be changed. This MAC Address is unique for each available port.
• IP Address / CIDR Mask (8 to 30) – Use this box to enter the IP Address and CIDR (Classless
Inter-Domain Routing) Subnet Mask.
The configured subnets must be unique when in Router Mode. Overlapping the
subnets is not allowed and such configuration requests will be rejected.
Figure 6-12. Configuration | Interface | FE Mgt Page
6–19
MN-CDM840
Revision 3