Ecm Operation - Comtec CDM-840 Installation And Operation Manual

CDM-840 Remote Router
Appendix G
G.3

ECM Operation

For detailed information, see:
• G.1.1 ECM Terminology and G.1.2 Functional Overview in this appendix, for
descriptions of the terms used in this section.
•
Chapter 6. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT and Chapter 7.
SERIAL-BASED REMOTE PRODUCT MANAGEMENT in this manual.
•
Chapter 6. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT and Chapter 7.
SERIAL-BASED REMOTE PRODUCT MANAGEMENT in the CDD-880 Multi Receiver
Router Installation and Operation Manual (CEFD P/N MN-CDD880).
•
Appendix G. ENTRY CHANNEL MODE SWITCHING in the adjunct CEFD publication
VMS v3.x.x VIPERSAT Management System User Guide (CEFD P/N MN/22156).
The CDM-840 and CDD-880 provide several means for configuring ECM operation via Remote
Product Control with a user-supplied PC:
•
Serial-based Remote Control Interface using a terminal emulation program or Windows
Command-line. See Sect. G.3.1.
•
CDM-840 and CDD-880 HTTP (Web Server) Interfaces using a compatible Web browser. See
Sect.G.3.2.
•
Ethernet-based Simple Network Management Protocol (SNMP) using a Network
Management System (NMS) and Management Information Base (MIB) File Browser.
COMTECH EF DATA RECOMMENDS USE OF THE ETHERNET-BASED SNMP INTERFACE
AND SERIAL-BASED REMOTE CONTROL INTERFACE ONLY FOR ADVANCED USERS.
COMTECH EF DATA STRONGLY ENCOURAGES USE OF THE CDM-840 AND CDD-880
HTTP INTERFACES FOR MONITOR AND CONTROL (M&C) OF THE CDM-840 OR
CDD-880.
THE SERIAL AND HTTP INTERFACE FIGURES FEATURED THROUGHOUT THIS
APPENDIX ARE INTENDED FOR USER REFERENCE ONLY AND ARE SUBJECT TO
CHANGE. THE FIRMWARE INFORMATION (I.E., REVISION LETTERS, VERSION
NUMBERS, ETC.) AS DISPLAYED MAY DIFFER FROM YOUR SETUP.
G–10
MN-CDM840
Revision 3