CDM-840 Remote Router
Appendix D
Do these steps to configure the CDM-840 for VersaFEC ACM operation from the specified HTTP
Interfaces:
1. Configure a route from the CDD-880 to the CTOG-250 for the Management IP Address of the
CDM-840.
2. Use the CDM-840 HTTP Interface 'Configuration | WAN | Mod | ACM' page (Figure D-3) to
configure the Target Es/No margin and the Max ModCod.
Sect. 6.3.3.2.2.2 Configuration | WAN | Mod | ACM (Adaptive Coding and
Modulation) in Chapter 6. ETHERNET-BASED REMOTE PRODUCT
MANAGEMENT
1) The recommended value for the target margin in order to maintain the link
2) The Max ModCod should be configured to the maximum ModCod that this
3. Enable ACM.
Figure D-3. CDM-840 HTTP Interface – Configuration | WAN | Mod | ACM Page
Comtech EF Data CTOG-250 Comtech Traffic Optimization Gateway with
•
CDM-800 Gateway Router Installation and Operation Manual (CEFD P/N
MN-CTOG250)
Comtech EF Data CDD-880 Multi Receiver Router Installation and Operation
•
Manual (CEFD P/N MN-CDD880)
at Ku is at least 0.5db.
terminal can achieve given the link budget, antenna, look angle, BUC
power, etc.
D–7
MN-CDM840
Revision 3