Configure Dpc - Comtec CDM-840 Installation And Operation Manual

CDM-840 Remote Router
Appendix M
M.3.1.1

Configure DPC

Do these steps:
1. In the ACM Demodulator Settings section of the CDD-880 HTTP Interface 'Configuration |
WAN | ACM' page, set the corresponding CDM-840 Management IP Address. If the system
is running dSCPC, this address is set automatically. Once you set this address and click
[Submit], the CDD-880 begins to send LQRMs.
2. In the Tx Dynamic Power Control (DPC) Configuration section of the CDM-840 HTTP
Interface 'Configuration | WAN | Mod | DPC' page, use your network's link budget
information to enter the terminal's Maximum Data Rate and the Tx Power Margin. Click
[Submit] when done.
3. If operating with ACM: Use the drop-down list in the Tx ACM Configuration section of the
CDM-840 HTTP Interface 'Configuration | WAN | Mod | ACM' page to select the desired
Max MODCOD. Click [Submit] when done.
M–19
MN-CDM840
Revision 3