Comtec CDM-840 Installation And Operation Manual page 194

CDM-840 Remote Router
Serial-based Remote Product Management
Command Number of
Parameter (Instruction Arguments for
Type Code Command or
& Qualifier) Response to Query
Geographical
Log
Information
(cont.)
Traffic IP IG1= 18 bytes
Current N/A 1 byte
Software
Image
Management IPA= 18 bytes
IP Address
GE Link LC1= 1 byte
Configuration
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 and 57)
WWWW=hex representation of the weeks field (weeks since 1/6/1980)
SSSSSSSS=hex representation of the seconds field (seconds this week)
FFFFFFFF=hex representation of the Tx frequency
BBBBBBBB=hex representation of the Tx symbol rate
M=bitmap for exclusion setting from user, and if locked from the router bit,
where:
0=lock bit
1=exclusion bit
AAAA=Latitude from user input
OOOOO=Longitude from user input
NNNNNNNN=Satellite naming string (from 1 to 8 characters)
Command or Query.
Sets or returns the IP Address and network prefix for the 10/100 BaseT
Ethernet Traffic port, in the form xxx.xxx.xxx.xxx/yy, where:
xxx.xxx.xxx.xxx=the IP Address
yy=the network prefix (8-30)
EXAMPLE: <0/IG1=192.168.001.004/24[cr]
Query Only.
Returns active software image in the form x, where:
1=Bulk Image #1 currently active
2=Bulk Image #2 currently active
EXAMPLE: <0/IMG?[cr]
>0000/IMG=2[cr][lf]
Command or Query.
Sets or returns the IP Address and network prefix for the 10/100 BaseT Fast
Ethernet FE Management port, in the form xxx.xxx.xxx.xxx/yy, where:
xxx.xxx.xxx.xxx=the IP Address
yy=the network prefix (8-30)
EXAMPLE: <0/IPG=192.168.001.004/24[cr]
Command or Query.
Sets or returns the 10/100/1000 BaseT Gigibit Ethernet GE traffic port
Interface Mode in the form x, where:
0=Auto Negotiate
1=1000 Mbps Full Duplex
2=100 Mbps Full Duplex
3=100 Mbps Half Duplex
4=10 Mbps Full Duplex
5=10 Mbps Half Duplex
EXAMPLE: <0/LC1=3[cr]
7–26
Response to Query
Command (Instruction Response to Query
(Target to Code & (Target to Controller)
Controller) Qualifier)
IG1= IG1? IG1=xx.xxx.xxx.xxx/yy
IG1? (see Description
IG1* of Arguments)
IG1#
N/A IMG? IMG=x
(see Description of
Arguments)
IPA= IPA? IPA=xx.xxx.xxx.xxx/yy
IPA? (see Description
IPA* of Arguments)
IPA#
LC1= LC1? LC1=x
LC1? (see Description of
LC1* Arguments)
LC1#
MN-CDM840
Revision 3