Confirming Ethernet Setup - Novatel ProPak6 User Manual

Chapter 4
6. Enter the IP address, Subnet mask and Default gateway for the Ethernet port on the computer.

Ensure the Ethernet settings used for the computer are compatible with the Ethernet
settings on the ProPak6 receiver.
For example, the following settings are compatible with the ProPak6 receiver settings
used in Section 4.2.1 Static IP Address Configuration—Receiver on page 74:
7. Click the OK button.
The Local Area Connection Properties window appears.
8. Click the Close button.
The Local Area Connection Status window appears.
9. Click the Close button.
10. Proceed to Section 4.2.4, Confirming Ethernet Setup on page 76.
4.2.4

Confirming Ethernet Setup

1. Connect the computer to the ProPak6 receiver using an Ethernet cross-over cable.
2. Connect to the receiver using NovAtel Connect or any third party terminal program that supports
TCP/IP connections. Use the static IP address and port number assigned to the ProPak6 receiver in
Section 4.2.1 Static IP Address Configuration—Receiver on page 74.
The figure below shows the New Connection window in NovAtel Connect with the example Ethernet
settings used in Section 4.2.1.
76
ip address = 192.168.74.11
subnet mask = 255.255.255.0
gateway = 192.168.74.1
ProPak6 Installation and Operation User Manual 4
Ethernet Configuration