Antenna And External Oscillator Ports; Power Port; Ethernet, Com Or Usb Device Ports - Novatel ProPak6 User Manual

Chapter 2
2. Use a coaxial cable (user supplied) to connect an antenna to the TNC ANT port on the back face of
the ProPak6 (Figure 5). Refer also to Section 3.1.16, Antenna LNA Port on page 43.
3. Use a coaxial cable (user supplied) to connect an external oscillator to the BNC OSC port on the
back face of the ProPak6 (Figure 5). Refer also to Section 3.1.17, External Oscillator Port (model
dependent) on page 43.
 The external oscillator is an optional model. If the dual-antenna model is used, refer
to Section 2.5, Dual Antenna Configuration and Installation on page 25 for
installation instructions.
Refer to the Input/Output Connectors section of A.2, ProPak6 Specifications on page 111.
4. The power cable connector (included) is keyed to the PWR 9-36 VDC connector (Figure 6) on the
back of the ProPak6. Line up the red dot on the cable with the red line on the connector port and
insert. Refer also to Section 3.2.1, Applying Power to the Receiver on page 43.
5. Use the appropriate cable to connect a computer to the COM port, Ethernet
port on the back of the ProPak6 (Figure 7).

COM ports are configurable to RS-232 or RS-422. Refer to Section 3.1.13.1,
Configure COM 1, 2 and 3 on page 42 for configuration instructions.
24
Figure 5: Antenna and External Oscillator Ports
Figure 6: Power Port
Figure 7: Ethernet, COM or USB Device Ports
ProPak6 Installation and Operation User Manual Rev 4
Installation
port or DEVICE