Chapter 2
This chapter contains instructions and tips to install the ProPak6 and create a GNSS receiver system.
2.1
Additional Equipment Required
Refer to Chapter 1, Introduction on page 15 for a list of components included with the Propak6. In order
for the receiver to perform optimally, the following additional equipment is required:
•
At least one GNSS antenna and antenna cable with a TNC male connector at the receiver end. For
example, a quality, dual-frequency GNSS antenna such as NovAtel's GPS-702-GG or ANT-A72GA-
TW-N for airborne/high speed applications. See the NovAtel website
gnss-antennas) for information on a variety of quality antennas available to meet your form factor
and performance needs.
User Supplied Additional Equipment (as required)
•
A quality coaxial cable and interconnect adapter cable as necessary (user-supplied)
•
A Windows based computer
•
A means of communicating between the ProPak6 and computer or other external devices:
•
Ethernet cable
•
USB micro-B cable
•
RS-232 serial cable
•
RS-422 serial cable
•
A cellular link
•
A cell antenna such as PCTEL Inc., MLPV800 (12023303) and magnetic mount such as PCTEL Inc.,
GMHFML195C (12023300)cellular radio antenna cable
•
Bluetooth link
•
Wi-Fi network
Use a serial COM or USB connection to communicate with the receiver first. This
provides the ability to configure the computer and ProPak6 before Wi-Fi, Ethernet,
Bluetooth or cellular are configured and used.
•
Real-time data collection, status monitoring and receiver configuration is possible through the
NovAtel Connect™ PC Utilities software is available from our web site:
info/documents/809.
When the ProPak6 is installed in a permanent location, such as in a building, it should
be protected by a lightning protection device according to local building codes. See
Lightning Protection Installation and Grounding Procedures on page 12.
20
Installation
ProPak6 Installation and Operation User Manual Rev 4
www.novatel.com/products/
www.novatel.com/support/