Sim Card Installation - Novatel ProPak6 User Manual

Chapter 5

2. Remove the SIM card cover and insert the SIM card.

Only use a mini-SIM card (25 mm x 15 mm). ProPak6 does not support micro-SIM
or nano-SIM cards.
3. Once the SIM card is correctly installed, secure the SIM cover to the base using a screwdriver.
Screws should be torqued to 4-6 inch-pound.

Failure to properly secure SIM cover will violate ProPak6 IP67 ingress rating.
4. Ensure a cellular antenna is connected to the ProPak6 and turn the ProPak6 power on.
5. LOG CELLULARSTATUS ONCHANGED to display the modem and cellular connection status.
6. LOG CELLULARINFO ONCE to display modem and network information.
7. The CELLULARCONFIG command is issued to configure cellular parameters. Issue the following
commands:
CELLULARCONFIG POWER ON
CELLULARCONFIG APN <APN>
CELLULARCONFIG USERNAME <USERNAME>
CELLULARCONFIG PASSWORD <PASSWORD>
CELLULARCONFIG DATA ON
CELLULARCONFIG DATAROAM ON
8. If internet access is required over this interface, issue the SETPREFERREDNETIF CELL command.
9. Issue the SAVECONFIG command to save the configuration to Non-Volatile Memory (NVM)

Cellular data consumption and service charges are dependent on the configuration
of the ProPak6 receiver and data logging rates.

Refer to the
command details.
1.Optional—consult the cellular data provider to determine if required.
90
Figure 28: SIM Card Installation

enables/disables data connectivity on the configured APN
OEM6 Family Firmware Reference Manual
ProPak6 Installation and Operation User Manual Rev 4
Radio Configuration and Activation
enables/disables data connectivity when roaming
(OM-20000129) for log and
enables the radio
1
sets AP name
1
sets user name
1
sets APN password
.