Notices - Novatel ProPak6 User Manual

Notices

The following notices apply to the ProPak6 device.

Changes or modifications to this equipment not expressly approved by NovAtel Inc., could
result in violation of FCC, Industry Canada and CE Marking rules and void the user's
authority to operate this equipment.
FCC Notices
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
The ProPak6 has been tested and found to comply with the radiated and conducted emission limits for a
Class B digital device. The Class B limits are designed to provide reasonable protection against harmful
interference in a residential installation.
The equipment listed generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Re-orient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help

To maintain compliance with the limits of a Class B digital device, you must use properly
shielded interface cables (such as Belden #9539 or equivalent) when using the serial data
ports, and double-shielded cables (such as Belden #9945 or equivalent) when using the I/O
strobe port.
Industry Canada
ProPak6 Class B digital apparatus complies with Canadian ICES-003.
ProPak6 appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Notice for Unlicensed Intentional Radiators
This device complies with Industry Canada's license-exempt RSS-GEN and RSS-210. Operation is
subject to the following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired operation
of the device.
ProPak6 Installation and Operation User Manual Rev 4 9