Siemens S120 Manual page 202

Hide thumbs Also See for S120:

Table of Contents

DC link components

An opening above the connections for the braking resistor (R1, R2) is provided in the cover

for connecting the cable to the braking resistor.

You must carefully observe the specified tightening torques.

Remove the three screws on the blanking cover.

Remove the blanking cover.

Install the Braking Module instead of the blanking cover and

secure it with the blanking cover screws that were

previously removed.

Secure the connecting cable to the DC link with two screws

(Braking Module connection) and with two nuts (DC-link

connection).

- cover plate, top – step

- cover plate, left – step

- the front cover – step

Manual, (GH6), 04/2014, 6SL3097-4AL00-0BP4