Basic Functions Without Main Greeting; Enable The Mailboxes For All Installed Extensions - NEC univerge sv8100 User Manual

Issue 7.00
B
S 4
ASIC
ECTION
To make the InMail answer, the following programming must be done. The example
shown is for a 8-port InMail. Extension, Group and Pilot Numbers shown can be
adjusted as needed per installation requirements.
E
S 5
NABLE THE
ECTION
Since by default only extensions 200-263 have Subscriber Mailboxes, you should
enable additional Subscriber Mailboxes for all installed extensions.
To enable additional Subscriber Mailboxes:
1.
2.
1 - 4
F
UNCTIONS WITHOUT
Set first port of In-Mail to 25, changing this PRG requires a CHS2U GW
47-01-17
reset.
Verify at least one resource is set to ICM/TRK or Common.
10-09-01
Set TEL Group Pilot 64 to 555 (Note: digit 5 is set to 4 digits by default).
11-07-01
Never use Group 1, as this is the default group for all extensions.
Set extension 224~231 to DP
15-03-01
Set extension 224~231 to Special.
15-03-03
Put 224~231 in Group 64.
16-02-01
Assign priorities 1~8 to 224~231.
16-02-02
Set Group 64 name to Voice Mail.
16-01-01
Set Group 64 to Circular.
16-01-04
Set Group 64 to Busy/No Answer.
16-01-10
Set to Group 64.
45-01-01
M
AILBOXES FOR ALL
.
Be aware that mailboxes beginning with a leading digit of either 0, * and # are not
supported.
In 47-02-01 Mailbox Type, enter 1 to enable a Subscriber Mailbox for each
extension as a 'Person' mailbox.
To make programming easier, consider associating a mailbox number with a station
port. For example, mailbox 1 should correspond to port 1, which in turn corresponds
to extension 200.
In 47-02-02 Mailbox Number, select the extension number to be associated with
the mailbox you are programming.
M G
AIN REETING
I
NSTALLED
E
XTENSIONS
Quick Setup