Voice Mail Setup; Basic Voice Mail Programming - NEC DS1000 Quick Setup Manual

5. Enter the access option for the selected trunk +
0 = No access
1 = Incoming only
2 = Outgoing only
3 = Full access (both incoming and outgoing)
6. Enter the access option for the next consecutive trunk.
Press
Press
Press

Voice Mail Setup

Prior to programming, follow the instructions that came with your Voice Mail and connect the Voice Mail
ports to the appropriate extension ports. If you are using the DS1000 PFT/MDM port for a Power Failure
Telephone or Modem Cut-through, do not use extension 316 for Voice Mail.

Basic Voice Mail Programming

The basic Voice Mail programming is divided into four parts:
Part I: Set up the Voice Mail Hunt Group.
Part II: Enable Voice Mail programming.
Part III: Set up the Voice Mail ports.
Part IV: Program the Voice Mail system.
Part I: Set Up the Voice Mail Hunt Group
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
0510:ACD/UCD GRP ID
GROUP NUM?1
3. Enter the number of the UCD Hunting Group you want to use for Voice Mail (1-8) +
0510:ACD ID-GROUP:n
EXT NUM?nnn
4. Enter the master number (e.g., 700) for the Voice Mail hunt group +
0510:ACD ID-GROUP:n
OVERFLOW DEST?NONE
5. Press
Part II: Enable Voice Mail Programming
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
0201:TENANT OPTIONS
CALL WAIT?nnn
3. Press
0201:TENANT OPTIONS
V-MAIL INSTALLED?nn
DS1000/2000 Quick Setup Guide
OR
CONF to go back to step 4 and select another trunk.
OR
CONF twice to go back to step 3 and select another extension.
OR
CONF three times to exit program 1803.
0510 + HOLD . You see:
CONF twice to exit program 0510.
0201 + HOLD . You see:
Vol Up until you see:
Section 1: Start-up Programming
VOL Up .
Section 1: Start-up Programming
HOLD . You see:
VOL Up . You see:
1
1-11