ABB relion REF615 Applications Manual page 66

Section 3
REF615 standard configurations
DEFLPDEF2_OPERATE
EFPADM2_OPERATE
DEFHPDEF1_OPERATE
EFPADM3_OPERATE
PDNSPTOC1_OPERATE
NSPTOC1_OPERATE
NSPTOC2_OPERATE
CBXCBR1_SELECTED
INTRPTEF1_OPERATE
ARCSARC1_OPERATE
ARCSARC2_OPERATE
ARCSARC3_OPERATE
GUID-4F81507A-B5DF-4FCD-A5F4-B51E9E683345 V1 EN
Figure 30: Autoreclosing function
60
The optional autoreclosing function is configured to be initiated by operate signals
from a number of protection stages through the INIT_1...5 inputs. It is possible to
create individual autoreclose sequences for each input.
The autoreclosing function can be inhibited with the INHIBIT_RECL input. By
default, few selected protection function operations are connected to this input. A
control command to the circuit breaker, either local or remote, also blocks the
autoreclosing function via the CBXCBR1_SELECTED signal.
The circuit breaker availability for the autoreclosing sequence is expressed with the
CB_READY input in DARREC1. This signal is not connected in the configuration.
The open command from the autorecloser is connected directly to binary output
X100:PO3, whereas the close command is connected directly to binary output
X100:PO1.
Set the parameters for DARREC1 properly.
Check the initialization signals of DARREC1.
OR6
B1 O
B2
B3
B4
B5
B6
OR6
B1 O
B2
B3
B4
B5
B6
OR6
B1 O
B2
B3
B4
B5
B6
OR6
B1 O
B2
B3
B4
B5
B6
PHIPTOC1_OPERATE
PHHPTOC2_OPERATE
PHHPTOC1_OPERATE
X120_BI3_CB_OPENED
OR
B1 O
B2
DARREC1
INIT_1 OPEN_CB
INIT_2 CLOSE_CB
INIT_3 CMD_WAIT
INIT_4 INPRO
INIT_5 LOCKED
INIT_6 PROT_CRD
DEL_INIT_2 UNSUC_RECL
DEL_INIT_3 AR_ON
DEL_INIT_4 READY
BLK_RECL_T ACTIVE
BLK_RCLM_T
BLK_THERM
CB_POS
CB_READY
INC_SHOTP
INHIBIT_RECL
RECL_ON
SYNC
1MRS756378 S
DARREC1_OPEN_CB
DARREC1_CLOSE_CB
DARREC1_INPRO
DARREC1_UNSUC_RECL
REF615
Application Manual