Configuring Local Logging - Dell M6220 User Configuration Manual

Command
test copper-port tdr
interface
show copper-ports tdr
interface
[ ]
show fiber-ports optical-
interface
transceiver [

Configuring Local Logging

Beginning in Privileged EXEC mode, use the following commands to
configure the type of messages that are logged and where the messages are
logged locally.
Command
configure
logging on
logging audit
logging cli-command
logging web-sessions
logging snmp
232
Monitoring and Logging System Information
Purpose
Perform the Time Domain Reflectometry (TDR) test to
diagnose the quality and characteristics of a copper cable
attached to the specified port. SFP, SFP+, and QSFP
cables with passive copper assemblies are not capable of
performing TDR tests.
CAUTION: Issuing the test copper-port tdr command
will bring the interface down.
The interface is specified in unit/slot/port format. For
example 1/0/3 is GbE interface 3 on unit 1 of the stack.
Display the diagnostic information collected by the test
copper-port tdr command for all copper interfaces or a
specific interface.
Display the optical transceiver diagnostics for all fiber
] ports. Include the
the specified port.
Purpose
Enter Global Configuration mode.
Globally enables logging.
Enable switch auditing.
Enable CLI command logging
Enable logging of the switch management Web page visits.
Enable logging of SNMP set commands.
interface
option to show information for