Error Code Details - Canon CLC5100 Series Manual

3.1 Error Code Details

3.1.1 Error Code Details
CLC5100 / CLC4000
CPU on the machine's image processor and DC controller PCB is equipped with a mecha nism to check the condition
of the machine (sensors, in particular). The mechanism runs a check as necessary and indicates the presence of an
error upon detection.
See the tables that follow for descriptions of codes; you may check these codes using 'JAM/ERROR' under
'DISPLAY' in service mode.
'0001' will be used for the detailed code column of errors without a detailed code.
Reference
1. If the self diagnosis mechanism has been activated, you can reset the machine by turning its power switch off and
then on. This, however, does not apply to 'E000'; if allowed with the hermistor out of order, such would heat and
damage the fixing roller.
2. If 'E005' (ADD CLEANING BELT) is indicated, replace the cleaning web and execute 'E005 RLS' of 'FUSER'
under 'FUNC' in service mode.
3. Even after clearing the E indication by turning off the power switch, a description of the last E indication may be
checked using 'JAM/ERROR' under 'DISPLAY' in service mode.
Clearing E000
1) Start service mode, and select 'FUSER' under 'FUNC'.
2) Press 'E000 RLS'.
3) Turn off and then on the power switch.
Clearing E005
1) Start service mode, and select 'FUSER' under 'FUNC'.
2) Press 'E005 RLS'.
3) Turn off and then on the power switch.
Clearing E075
1) Start service mode, and select 'F MISCp' under 'FUNC'.
2) Press 'E075 RLS'.
3) Turn off and then on the power switch.
Clearing 'E004'
1) Turn off the power switch.
2) Disconnect and connect the power plug from and to to the power outlet.
3) Turn on the power switch.
Chapter 3
0004-9338
3-1