Chapter 3 Error Code; Error Code Details - Canon iR1018 Series Portable Manual

Chapter 3 Error Code

3.1 Error Code Details

3.1.1 Error Code Details
/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /
Display Detail Code
Code
E000 0000
E001 0000
0001
E002 0000
E003 0000
0001
E010 0000
E019 0000
0001
E100 0000
E196 0001
0002
E197 0000
E716 0000
Main Cause/Symptom
Startup error
The temperature detected by the main or sub thermistor does
not rise to the specified value during startup control.
Abnormally high temperature (detected by main thermistor)
The main thermistor detected an abnormally high temperature
(235 deg C) during temperature control.
Abnormally high temperature (detected by sub thermistor)
The sub thermistor detected an abnormally high temperature
(300 deg C) during temperature control.
Low temperature during temperature control.
The target temperature is not reached during temperature
control.
Abnormally low temperature (detected by main thermistor)
After the temperature detected by the main thermistor has
reached the specified value, it does not reach the specified
value during initial rotation.
Abnormally low temperature (detected by sub thermistor)
After the temperature detected by the sub thermistor has
reached the specified value, it does not reach the specified
value during initial rotation.
Main motor failure
The main motor is faulty.
Waste toner full detection
The waste toner full state was detected.
Waster toner full detection sensor is faulty.
The waste toner full state was detected continuously for five or
more seconds while the main motor was turning.
BD detection PCB failure
The BD detection PCB is faulty.
Flash ROM write/read error
The write/read of Flash ROM in the image processor PCB is
faulty.
PCL ROM write/read error
The write/read of PCL ROM in the image processor PCB is
faulty.
Printer engine communication error
Erroneous communication between the DC controller PCB and
image processor PCB was detected.
Erroneous communication with optional cassette
Disconnection of the optional cassette was detected after
power-on, detection of normal connection to the optional
cassette, and start of communication.
T-3-1
Countermeasure
- Check the fixing film connector.
- Replace the fixing film unit.
- Replace the DC controller PCB.
- Check the connector of the fixing film unit.
- Replace the fixing film unit.
- Replace the DC controller PCB.
- Check the connector of the fixing film unit.
- Replace the fixing film unit.
- Replace the DC controller PCB.
- Check the connector of the fixing film unit.
- Replace the fixing film unit.
- Replace the DC controller PCB.
- Check the connector of the fixing film unit.
- Replace the fixing film unit.
- Replace the DC controller PCB.
- Check the connector of the fixing film unit.
- Replace the fixing film unit.
- Replace the DC controller PCB.
- Check the connector of the main motor.
- Replace the main motor.
- Replace the DC controller PCB.
Replace the drum unit
- Check the connector of the waster toner full sensor.
- Replace the waste toner full sensor.
- Replace the DC controller PCB.
- Check the connector of the BD detection PCB.
- Replace the laser scanner unit.
- Replace the DC controller PCB.
- Replace the image processor PCB.
- Replace the PCL PCB.
- Replace the image processor PCB.
- Check the connectors of the DC controller PCB and image
processor PCB.
- Replace the DC controller PCB for normal connection.
- Replace the image processor PCB.
- Check the connectors of the optional cassette PCB and DC
controller PCB.
- Replace the optional cassette PCB for normal connection.
- Replace the DC controller PCB.
Chapter 3
0013-1429
7