5)Pull out the solenoid arm [5] with your fingers, open the shutter, and clean the sensor surface [6] with a blower
brush.
Do not wipe the sensor surface too strong. Wipe out toner as raking it.
6)Restore the solenoid arm in place with your fingers, and close the shutter.
7)After mounting the SALT sensor, execute the Service Mode FUNC>INSTALL>WINCLR Y/M/C/K
(corresponding color).
1.4.8 How to Disassemble and Clean the SALT Sensor Unit
CLC5100 / CLC4000
1)Remove the second scoop up sheet [1] (two mounting screws) and the lower mylar [2] (two mounting screws)
respectively.
F-1-12
[3]
[2]
F-1-13
F-1-14
[1]
Chapter 1
0002-8834
1-33