Table of Contents
Advertisement
2.2.5 Adjusting the Pick
Up Timing (paper deck)
CLC5100 / CLC4000
If a discrepancy is found in the image leading edge
margin on 'LTR' copies made using the paper deck,
correct the problem by performing the following
steps:
1) Place three or more sheets of 'LTR' paper in the
paper deck.
2) Start service mode, and select 'FUNC>P UP
TMG'.
3) Execute 'PK ADJ D'.
The machine picks up a single sheet of paper.
4) Execute 'AK ADJ D' for a total of three times to
pick up three sheets of paper.
5) When pick up has ended, press 'DSEND D'.
2.2.6 Image Positioning
Correction
CLC5100 / CLC4000
In case image position shifts in every color as well as
the image positioning correction (Service Mode
'FUNC>IMG REG>AUTO ADJ') did not provide
any effects on the image shift problem, follow the
below procedures for adjustments.
1) Select the service mode 'TEST>PG>TYPE'. Set to
"6 (lattice pattern)" and press the start button. (A
test print will be printed out.)
2) Select the service mode 'OPTION>P OPT>REG
DISP'. Set to "1" and then press the OK key.
3) Press the reset key twice to exit from the service
mode.
4) Press the user mode key to enter the user mode.
5) Select "Image Positioning Correction." (The
display indicates as below.)
0002-3613
6) Select "Manual Correction" key.
7) On the test print already made, on the basis of
magenta color, measure how mm other three colors
are shifting from the magenta.
8) In terms of any shifts in main scanning direction,
make an adjustment by changing values of REG
H(rough adjustment) / REG HS (fine adjustment).
REG H: In case the numerical value is increased by
REG HS: In case the numerical value is increased by
0002-5726
9) In terms of any shifts in sub scanning direction,
make an adjustment by changing the REG V value.
REG V: In case the numerical value is increased by
10) Select "Auto Correction" key.
11) Press the OK button to exit from the user mode.
12) On the lattice patterned test print, check if the
image is normal.
13) Select the service mode 'OPTION>P OPT>REG
DISP'. Set to "0" and press the OK key.
14) Press the reset key twice to exit from the service
mode.
REG-H
REG-HS
Y
124
3
AU TO
A D J U S T M E N T
C
150
3
M A N UA L
A D J U S T M E N T
BK
154
0
F-2-19
"+16," the position will shift to the rear side by 1
mm.
"+32," the position will shift to the rear side by
0.5mm.
"+16," the position will shift to the trailing edge
by 1mm.
In case the image position is not good, re adjust
the image.
In case the image position is good, go to the
next step.
Chapter 2
C
REG-V
ACS
113
F U L L
C O L O R
128
B L AC K
O R I G I N A L
RECOGNITION
113
C E N T E R
OK
S H I F T
2-11
Advertisement
Table of Contents
