Adjusting The Position Of The Duplexing Unit Paper Deflecting Plate Solenoid (Sl11); Adjusting The Position Of The Duplexing Unit Stacking Assembly Paper Guide Plate; Adjusting The Position Of The Duplexing Unit Feeding Roller Solenoid (L13) - Canon CLC5100 Series Manual

Chapter 2
2.8.7
Adjusting
Position of the Duplexing
Unit Paper Deflecting
Plate Solenoid (SL11)
CLC5100 / CLC4000
1) Remove the duplexing unit.
2) Fix the solenoid in place with a mounting screw [3]
after moving the solenoid to the delivery direction
while the plunger [2] of the solenoid [1] is pushed
in.
rear
F-2-57
2.8.8 Adjusting
Position of the Duplexing
Unit Stacking Assembly
Paper Guide Plate
CLC5100 / CLC4000
1) Select A3 or 11x17, and copy on the first side of a
two sided copy.
2) Slide out the duplexing unit to the front.
3) Measure the distance L of the paper guide plate [1].
A3 : L = 297.5 ±0.5 mm
11x17 : L = 297.5 ±0.5 mm
2-40
the
0002-4859
[1]
[2]
[3]
the
0002-5785
[1]
F-2-58
4) If the measurement is outside the standards, remove
the duplexing unit front cover.
5) Loosen the screw [2], and turn the adjusting screw
[3]; then, adjust the position of the paper guide plate
home position sensor.
F-2-59
2.8.9 Adjusting
Position of the Duplexing
Unit Feeding
Solenoid (L13)
CLC5100 / CLC4000
Let the feeding roller drop to the bottom of the duplex
feeding assembly on its own weight.At this time, fix
the solenoid [3] so that the end to end distance
between the lever [1] and the arm [2] is 1.5 ±0.5 mm
when the plunger of the solenoid is pushed.
L
[1]
[2]
[3]
the
Roller
0002-5789