Cleaning The Transfer Blade; Cleaning The Grounding Roller; Cleaning The Developing Assembly Bottom Cover And The Bearing - Canon CLC5100 Series Manual

1.4.4 Cleaning the Transfer Blade

CLC5100 / CLC4000
1) After removing the transfer blade as in step 5), stand the transfer blade assembly [1] on its end as shown in the
following figure; then, wipe the blade [2] and the plastic film [3] with lintfree paper with bottom to top motions
or clean it with a blower brush.

1.4.5 Cleaning the Grounding Roller

CLC5100 / CLC4000
1) Remove the three screws, and remove the grounding roller unit.
2) Clean the toner off the surface of the roller with lint free paper.

1.4.6 Cleaning the Developing Assembly Bottom Cover and the Bearing

CLC5100 / CLC4000
If you replaced the photosensitive drum or the cleaning blade, be sure to clean the developing assembly bottom cover
and the bearing as follows:
1) Slide out the process unit from the copier.
2) Remove the developing assembly.
3) Remove the toner found in the area of the developing assembly bottom cover [1] indicated in the figure using a
blower brush or lint free paper.
4) If toner is found sticking to the developing assembly front side plate or the bearing [2] of the rear side plate, dry
wipe it using lint free paper.
[1]
F-1-9
[3]
[2]
Chapter 1
0002-2905
0002-2907
0002-1929
1-31