Canon CLC5100 Series Manual page 61

2.2.3
Checking
Adjusting the Non Image
Width and Margin
CLC5100 / CLC4000
Make adjustments in the following order:
Left right registration
Image margin
Image reading start position (ADJ XY)
Image margin (check)
a.Adjusting the Left/Right Registration
1) Make 10 copies each using all cassettes,
multifeeder, duplexing unit, and paper deck, and
check the left/right margin.
2) If the margin is not as indicated, perform the
following:
Standard Registration
3) Select 'FUNC > ATTRACT'.
4) Using 'ATT SLCT', select the pick up assembly
which is outside the specification.
5) Press 'ATT ON'. (Paper will be picked up
automatically and stopped retained on the transfer
belt.)
6) Make adjustments so that the distance L between
the front edge of paper [1] and the front side plate
[3] of the transfer unit [2] is 74.7 ±0.5 mm
(reference). (In the case of LTR, 83.7 ±0.5 mm.)
[1]
[3]
F-2-12
and
0002-5269
[2]
L
Using the Cassette as the source of Paper
1) Slide out the cassette from the machine.
2) Remove the cassette front cover.
3) Turn the adjusting screw [1] to adjust the position
of the horizontal registration plate.
To increase the registration at the front, turn the
adjusting screw to the left.
To increase the registration at the rear, turn the
adjusting screw to the right.
4) After the adjustment, be sure to execute 'paper
width basic value registration'.
F-2-13
Using the Multifeeder as the source of Paper
Turn the screw [1] to move the tray position so that the
standard value is attained.
F-2-14
Chapter 2
[1]
[1]
2-9