Canon CLC5100 Series Manual page 193

No
Motor
.
10 M19 (duplex feed motor)
11 M15 (polishing/oil removing
motor)
12 M24Y, M24M, M24C, M24Bk
(primary charging wire cleaner
motor)
13 Fixing web motor
14 M12 (Transfer belt cleaning
motor)
15 M2 (mirror slant correction motor
for Y)
16 M3 (mirror ratio correction motor
for Y)
17 M5 (mirror slant correction motor
for C)
18 M6 (mirror ratio correction motor
for C)
19 M7 (mirror slant correction motor
for Bk)
20 M8 (mirror ratio correction motor
for Bk)
21 M13 (transfer belt swing motor)
22 M23 (duplexing paper jogging
guide motor)
23 M28 (duplex reversal motor)
Details of MTR
Control
Operates for 10 sec, stops for 3 sec, and then operates
for 10 sec and stops.
Its operation stops in response to a press on the Stop
key.
Rotates CCW/CW for 10 sec, stops for 3 sec, rotates
CCW for 10, and then stops.
Its operation stops in response to a press on the Stop
key.
Cleans by a single back and forth trip.
Operates for 5 sec and then stops.
Operates for 1 sec and then stops.
M2 (mirror slant correction motor for Y)
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Rotates CW for a single full turn, rotates
CCW for a single turn, and then stops.
Executes home position detection, stops for 3 sec,
moves to A4 position, stops for 3 sec, moves to B4
position, stops for 3 sec, moves to A4R position, stops
for 3 sec, moves to B5R position, stops for 3 sec, and
then moves to home position.
Rotates for draw in operation for 3 sec, rotates for
feed out operation for 3 sec, stops for 1 sec, rotates for
draw in for 3 sec, rotates for feed out for 3 sec, and
then stops.
Chapter 5
5-63