Pickup/Feeding System - Canon CLC5100 Series Manual

2.8 Pickup/Feeding System

2.8.1 Registering
Cassette/Multifeeder
Paper Width
Setting (under 'FUNC')
CLC5100 / CLC4000
You must register the paper width basic setting if you
have
Replaced the paper width VR of the copier
(including the multifeeder).
Adjusted the front/rear registration for the cassette.
For the cassette, you must register the setting for
'STMTR' and 'A4R'; for the multifeeder, you must
register the setting for 'A6R', 'A4R', and 'A4'.
a. Cassette 1 or 2
1) Slide out the cassette you want to register the
setting for, and set the paper width guide plate
inside the cassette to A4R.
2) Set the cassette in the copier.
3) Check that the basic setting is indicated on the
'CST AD' screen of 'FUNC' in service mode on the
control panel.
4) Select the size of the cassette for which you want to
register the basic setting:
UP A4R (cassette 1)
LOW A4R (cassette 2)
5) Note that basic setting 1 has been registered.
6) Slide out the cassette you want to register the
setting for, and set the paper width guide plate
inside the cassette to STMTR.
7) Set the cassette in the copier.
8) Check that the basic setting is indicated on the
'CST AD' screen of 'FUNC' in service mode on the
control panel.
9) Select the size of the cassette for which you want to
register the basic setting:
the
Basic
0002-4304
UP STMTR
LOW STMTR
10) Note that basic setting 2 has been registered.
b. Multifeeder
1) Set the paper guide plate [1] of the multifeeder to
A4R (210 mm).
2) Note that the basic setting is indicated on the 'CST
AD' screen for 'FUNC' in service mode on the
control panel.
3) Select the size for which you want to register the
basic setting.
MF A4R
4) Note that basic setting 1 has been registered.
5) Set the paper guide plate [1] of the multifeeder to
A6R (105 mm) [3].
[3]
[1]
F-2-50
6) Check that the basic setting is indicated on the
'CST AD' screen under 'FUNC' in service mode on
the control panel.
7) Select the size for which you want to register the
basic setting.
MF A6R
8) Note that basic setting 2 has been registered.
9) Set the paper guide plate of the multifeeder to A4
(297 mm).
10) The basic setting is indicated on the 'CST AD'
screen under 'FUNC' in service mode on the control
panel.
11) Select the size for which you want to register the
basic setting.
Chapter 2
[2]
105mm
2-37