Canon CLC5100 Series Manual page 180

Chapter 5
Sub item
C/Y/K OFST
POTOFSTC/M/Y/K
<CCD> FUNCTION > CCD
Sub item
AUTO ADJ
LAMP
CCD MODE
CCD DISP
TARGET
5-50
FUNCTION > DC CON
Use it to enter the offset value for the image position correction
pattern.
Do not enter any values other than those on the service data
sheet.
Use it to enter the offset value for the potential sensor.
T-5-33
FUNCTION > CCD
Use it to specify the start of auto adjustment.The bar code data recorded
on the standard white plate is read, and offset adjustment, intensity
adjustment for the scanning lamp, and gain adjustment are executed in
sequence.
The display changes as follows: <R>RADY > Bar code > OeAdj >
Offdj > LampAdj > GainAdj > OeAdj > InitBAdj > Gz bar.
Remarks: Adjustments are made so that the value of point A is identical
to the setting obtained from the bar code data recorded on the standard
white plate.
Use it to indicate the level adjustment value of the scanning lamp.
Use it to indicate whether the mode selected in user mode is normal mode
or precious metal mode.
Remarks: 0: normal mode 1: precious metal mode
Use it to switch the display data for the following in service mode:
'FUNC>CCD'
Settings:
0: indicate display in normal mode
1: indicate data in precious metal mode
Standard: 0
Use it to display the shading adjustment correction value (target value of
point B).
BLUE: Use it to indicate the data of BLUE.
GREEN: Use it to indicate the data of GREEN.
RED: Use it to indicate the data of RED.
Description
Description