Canon CLC5100 Series Manual page 65

6) Fit the scanner cable on the pulley and the hook as
indicated in the Figure.
2
[6]
6
F-2-23
Take care not to damage the wire by the edge of the
metal plate.
Be sure to keep the four screws [6] loose during the
work.
7) Remove the screw [3] used in step 5.
8) Loosen the screw on the mirror positioning tool
(FY9 3040 000), and extend the arm [7] fully.
[7]
F-2-24
9) Set the mirror positioning tool [8] between the No.
1 mirror mount and the No. 2 mirror mount; then,
insert the pin [9] that comes with the mirror
positioning tool.
1
3
5,7
4
[6]
[7]
[9]
F-2-25
F-2-26
10) Using two screws [10], fit the metal fixing [10] of
the scanner cable to the No. 1 mirror mount through
the angular hole in the side plate.
[11]
F-2-27
Chapter 2
[8]
[8]
[9]
[10]
2-13