Canon CLC5100 Series Manual page 168

Chapter 5
Sub item
VSYC ADJ
MT RG UT
MLT CL
DK RG T
1REG LP
DK RG UT
5-38
ADJUST > FEED ADJ
Adjusts the image write start position in sub scanning direction.
Setting range: 0 to 255 Standard: 128 unit: about 0.11mm
A higher setting will cause a shift toward the rear.
Use it to adjust the image start position in sub scanning direction for heavy
paper from the multifeeder tray.
Settings range: 20 to 20 Standard: 0 unit: about 0.1mm
An increase in the value will cause a shift toward the trailing edge.
Use it to increase the leading edge margin by causing pickup of heavy
paper from the multifeeder and other sources and the activation of the feed
clutch to occur earlier than registration.
Settings range: 0 to 50 Standard: 0 unit: msec
An increase in the value will cause a shift toward the training edge.
Use it to adjust the image start position in sub scanning direction for thick
paper from the appear deck.
Settings range: 20 to 20 Standard: 0 unit: about 0.1mm
An increase in the value will cause a shift toward the trailing edge.
Use it to adjust the degree of arching copy paper at the rear of the registra
tion roller (paper stop timing).
Settings range: 6 to +6 Standard: 0
A higher setting will increase the arching.
Too low a setting can cause skew movement.
Use it to adjust the image start position in sub scanning direction for heavy
paper from the paper deck.
Settings range: 20 to 20 Standard: 0 unit: about 0.1mm
An increase in the value will cause a shift toward the trailing edge.
Description