Method: [All] - Kyocera TASKalfa 1800 Service Manual

Method: [All]

1. Load A4/letter paper.
2. Press the start key to output the original for adjustment.
3. Set the output the original for adjustment and press the start key.
4. Set the output the original for adjustment on the DP face up.
5. Press the start key to scan documents.
6. Press the start key. Auto adjustment of first side starts.
7. Set the output the original for adjustment on the DP face down.
8. Press the start key to scan documents.
9. Press the start key. Auto adjustment of second side starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem occurs
during auto adjustment, error code is displayed and operation stops. Should this happen,
determine the details of the problem and repeat the procedure from the beginning.
Error Codes
Codes
01
03
03
04
05
06
07
08
09
0a
0b
0c
0d
0e
0f
10
11
12
13
14
15
Automatic adjustment success
Black band detection error (scanner leading edge registration)
Black band detection error (scanner main scanning direction magnifica-
tion)
Black band is not detected (scanner leading edge registration)
Black band is not detected (scanner center line)
Black band is not detected (scanner main scanning direction magnifica-
tion)
Black band is not detected (scanner auxiliary scanning direction magnifi-
cation)
Black band is not detected (DP main scanning direction magnification far
end)
Black band is not detected (DP main scanning direction magnification
near end)
Black band is not detected (DP auxiliary scanning direction magnification
leading edge)
Black band is not detected (DP auxiliary scanning direction magnification
leading edge original check)
Black band is not detected (DP auxiliary scanning direction trailing edge)
White band is not detected (DP auxiliary scanning direction trailing edge
2)
DMA time out
Auxiliary scanning direction magnification error
Auxiliary scanning direction leading edge detection error
Auxiliary scanning direction trailing edge detection error
Auxiliary scanning direction skew 1.5 error
Maintenance request error
Main scanning direction center line error
Main scanning direction skew 1.5 error
1-3-76
2NC/2NF/2NG/2NN/3P7/3P8/3P9
Description