Dp Timing; Adjustment: Leading Edge Registration - Kyocera TASKalfa 1800 Service Manual

U071

DP Timing

Description
Adjusts the DP original scanning timing.
Purpose
Make the adjustment if there is a regular error between the leading or trailing edges of the original
and the copy image when the DP is used.
Method
1. Press the start key.
2. Press the system menu key.
3. Place an original on the DP and press the start key to make a test copy.
4. Press the system menu key.
5. Select the item to be adjusted.
Display
Front Head
Front Tail
Back Head
Back Tail

Adjustment: Leading edge registration

1. Change the setting value using change keys * or numeric keys.
* : Zoom/Paper selection key (Basic model), Right/Left arrow key (Advanced model)
For copy example 1, increase the value. For copy example 2, decrease the value.
Increasing the value moves the image forward and decreasing the value moves the image back-
ward.
2. Press the start key. The value is set.
Caution
If the first side is adjusted, check the second side and if adjustment is required, carry out the
adjustment.
If the above adjustment does not optimize the leading edge registration, proceed with the following
maintenance modes.
U034 -------- U071
(P.1-3-24)
Description
Leading edge registration. (first side)
Trailing edge registration. (first side)
Leading edge registration. (second
side)
Trailing edge registration. (second side)
Original
Setting
range
-30 to 30
-30 to 30
-30 to 30
-30 to 30
Copy Copy
example 1 example 2
Figure 1-3-10
1-3-37
2NC/2NF/2NG/2NN/3P7/3P8/3P9-2
Initial Change in
setting value per step
0
0
0
0
1
1
1
1