(1-4) Detaching and refitting the drive motors
Procedure
1. Remove three connectors.
2. Remove two screws and remove the
DP original conveying motor by pulling
upward and then forward out.
3. Remove two screws and remove the
DP original feed motor by pulling diago-
nal leftward and then forward out.
4. Remove two screws and remove the
DP switchback motor by pulling out for-
ward.
5. Check or replace the DP original con-
veying motor, the DP original feed
motor and the DP switchback motor
and refit all the removed parts.
Connecters
DP original
feed motor
DP switchback
motor
Figure 1-5-160
1-5-91
2NC/2NF/2NG/2NN/3P7/3P8/3P9
DP original
conveying motor
Screws
Screws
Screws