Encom iPULSE R User Manual page 98

The following table describes the settings associated with the TCP Client mode.
Field Name
Remote server IP
Remote server port
Out-connection
timeout
For ENCOM PULSE Link Version 2.2.6
Description
Enter the IP address of the TCP Server to which data received from the
client PULSE radio network will be sent.
This is an Internet Protocol version 4 (IPv4) address, specified in dotted
notation, as shown in the following example:
Enter the TCP port to which the data received from the client PULSE
radio network will be sent.
Set this value to the Listening port setting of the TCP Server radio.
The default server port is 20011.
Enter the maximum amount of time, in seconds, to keep the connection
active while it is idle (no data is being transferred). If this timeout is
exceeded, the connection is dropped.
The default in-connection timeout is 60 seconds.
Page 98
ENCOM PULSE Link
USER MANUAL
© 2012-2015 Encom Wireless Data Solutions Inc.