Encom iPULSE R User Manual page 22

7. ENCOM PULSE Link will detect the radio and attempt to communicate with it.
8. When PULSE Link is able to communicate with the radio, it will automatically retrieve its
configuration settings.
Note that when the status bar is red, you should not disconnect the serial cable from the
radio, nor should you remove power from the radio. Doing so could prevent the radio from
being able to communicate properly over the serial port (or the FSK port for FSK radios). If
this happens, you may have to use PULSE Link again to restore the radio's configuration.
9. If a product code has not yet been assigned to the 5000 series adapter card, you will be
prompted to do so:
Refer to the Setting the 5000 Series Radio Product Code
product code.
10.After the radio's configuration settings have been retrieved, the radio is shown as being on-
line.
For ENCOM PULSE Link Version 2.2.6
topic for instructions on setting the
Page 22
© 2012-2015 Encom Wireless Data Solutions Inc.
ENCOM PULSE Link
USER MANUAL