Connecting To A Pulse Radio - Encom iPULSE R User Manual

Connecting to a PULSE Radio

To connect to an ENCOM PULSE radio, follow the procedure listed below:
1. Run the ENCOM PULSE Link application on your computer.
2. The Status Bar
connect to a radio.
3. Power the PULSE radio with the provided wall mount power adapter, and then connect the
radio to your computer with the included USB cable.
4. ENCOM PULSE Link will detect the radio and attempt to communicate with it.
5. When PULSE Link is able to communicate with the radio, it will automatically retrieve its
configuration settings.
Note that when the status bar is red, you should not disconnect the USB cable from the radio,
nor should you remove power from the radio. Doing so could prevent the radio from being
able to communicate properly over the serial port (or the FSK port for FSK radios). If this
happens, you may have to use PULSE Link again to restore the radio's configuration.
For ENCOM PULSE Link Version 2.2.6
at the top right-hand corner of the application's window will prompt you to
Page 16
ENCOM PULSE Link
USER MANUAL
© 2012-2015 Encom Wireless Data Solutions Inc.