Table of Contents
Advertisement
R&S OSP
5.1.2 R&S OSP Module Slots
The R&S OSP offers three slots for installation of R&S OSP modules. The modules
are installed from the rear side of the instrument. A maximum of three R&S OSP
modules can be configured. If more R&S OSP modules are required, the R&S OSP
can be extended by the version R&S OSP150. The extension unit R&S OSP150 is
controlled from the R&S OSP120 or OSP130 by CAN bus Interface.
Refer to
Figure 5-4: R&S OSP Module Slots
The slots are designated with A11, A12 and A13. The same order is used when
addressing the modules; i.e. R&S OSP module 1 corresponds to slot A11 etc.
In principle the R&S OSP modules can be installed in the slots in any order. A slot
which is not occupied will be shown as empty by the OSP Panel application.
Module Slots
The depth of the module slot A11 is limited. Only modules with a depth < 70 mm like
the modules R&S OSP-B101, R&S OSP-B102, R&S OSP-B103, R&S OSP-B107,
R&S OSP-B111 or R&S OSP-B112 can be operated in this slot!
R&S OSP-B106 can be placed in slots A11+ A12 or A12 + A13.
For installation of the modules see the corresponding installation procedures.
5.1.3 R&S OSP120 Version12 and Module Slots
The R&S OSP120 Version 12 is designed with two slots in the front side in addition to
the three slots at the rear side as described above.
Figure 5-5: R&S OSP120 Version12 Module Slots at front side
Operating Manual 1505.3896.12 - 14
chapter 8.2
for detailed information on the extension unit R&S OSP150.
Slot A11
Slot A12F
Slot A12
Slot A13
Slot A13F
Instrument Functions
78
Advertisement
Table of Contents
