R&S Osp Panel; Linux Operating System - R&S OSP Operating Manual

R&S OSP
2.9.1.2 Specific mode of LAN Configuration
The R&S OSP120 can be configured to enable gateway routing.
The actual LAN configuration is set to mode -> DHCP-STATIC
The LAN configuration can be setup using the OSP Panel application. See
3.3.3.
The change over to DHCP-STATIC mode is achieved by the following SCPI command:
SYSTem:NETWork:STATic "<IpAddr>","<Netmask>","<Gateway>".
2.9.2 R&S OSP Panel
The R&S OSP120 has no elements for front panel operating. A "manual" operation is
achieved via the R&S application OSP Panel.
"OSP Panel" is a Windows application which can be used to access and control the
R&S OSP120 or the OSP130 from a remote computer through a LAN connection. The
OSP Panel allows full access to all R&S OSP functions.
To start the OSP Panel connection
4.
5.
6.
For detailed information about OSP Panel refer to the
Functions.

2.10 Linux Operating System

The R&S OSP is equipped with a Linux operating system which has been configured
according to the instrument's features and needs. Changes in the system configuration
can be necessary in order to
●
●
●
Operating Manual 1505.3896.12 - 14
Connect the R&S OSP to a LAN and determine its IP address; see Remote
Operation in a LAN. It is necessary to have a VISA library installed on your
computer.
Install the OSP Panel application on your computer (connected to the LAN). The
VISA libraries which are necessary for running the OSP Panel are available on a
separate disc (NI-VISA I/O Library)..
Start the OSP Panel, specify the correct IP address in the OSP Panel, and the
R&S OSP can be manually controlled.
Establish a LAN connection.
Customize the properties of the keyboard connected to the R&S OSP120.
Call up additional software tools.
Preparing for Use
chapter
chapter 3.3 R&S OSP Panel
29