Table of Contents
Advertisement
R&S OSP
Figure 5-17: Module R&S OSP-B103
The R&S OSP-B103 module is supplied with power and controlled from the R&S OSP
via a single connector on the R&S OSP-B103 printed circuit board. The connection to
the R&S OSP is done via a single connection cable.
The R&S OSP-B103 module is equipped with an on-board memory to store the
necessary configuration data of the module.
To OSP frame
(cable W 5 or 6 or 7)
Figure 5-18: Block Diagram Module R&S OSP-B103
When the module R&S OSP-B103 is configured within the R&S OSP, a manual
operation of the module can be performed via the OSP Panel. See
details.
For remote control operation see
See
Depending on the required application, several modules of the R&S OSP-B103 type
can be installed in one R&S OSP.
In the R&S OSP frame a maximum of three modules is possible. If more than three
modules are required, the extension unit R&S OSP150 must be used. For further
information on the extension unit R&S OSP150 see
Operating Manual 1505.3896.12 - 14
Interface logic
Relay drivers
2
I
C memory
Interface
connector
chapter 9.2.3
for details on the connector pin assignments.
Ch1
Ch2
Ch3
Ch4
Ch5
Ch6
Ch7
Ch8
Ch9
Ch10
Ch11
Ch12
Ch13
Ch14
Ch15
Ch16
GND
+28 V
Ch1
Ch2
Ch3
Ch4
Ch5
Ch6
Ch7
Ch8
Ch9
Ch10
Ch11
Ch12
Ch13
Ch14
Ch15
Ch16
Output Port
chapters 6
and 7.
chapter
Instrument Functions
chapter 3.3.9
for
8.2.
87
Advertisement
Table of Contents
