Table of Contents
Advertisement
R&S OSP
To OSP frame
(cable W5 or 6 or 7
Figure 5-22: Block Diagram Module R&S OSP-B106
When the module R&S OSP-B106 is configured within the R&S OSP, a manual operation
of the module can be performed via the OSP Panel. See
For remote control operation see
See
The module OSP-B106 has a double width. Therefore only one module can be
installed in one R&S OSP frame. If more than one module is required, the extension
unit R&S OSP150 must be used. For further information on the extension unit
R&S OSP150 see
The description above applies to further options of the R&S OSP as far as the option
has got a similar relay configuration. It will apply to the following modules:
Option
OSP-B132
5.2.6 DC MUX Module R&S OSP-B108
The module R&S OSP-B108 is a four pole one to six multiplexer for DC.
It is controlled equivalent to first Relay K11 of R&S OSP-B102.
Figure 5-23: Module R&S OSP-B108
The R&S OSP-B108 module is supplied with power and controlled from the R&S OSP
via a single connector on the R&S OSP-B108 printed circuit board.
Operating Manual 1505.3896.12 - 14
Module OSP-B106
Interface logic
Relay drivers
2
I
C memory
Interface
connector
chapter 9.2.6
for details on the connector pin assignments.
chapter
Relay configuration
6 x SPDT relay with N-Connectors, 12 GHz
K1
NO
NC
C
K2
NO
NC
C
K3
NO
NC
C
K4
NO
NC
C
K5
NO
NC
C
K6
NO
NC
C
chapters 6
and 7.
8.2.
Instrument Functions
chapter 3.3.6
for details.
91
Advertisement
Table of Contents
