Table of Contents
Advertisement
R&S OSP
Command
*CLS – CLear
Status
*ESE – Event
Status Enable
*ESR? – Event
Status Read
*IDN? –
IDentification
Query
*OPC –
OPeration
Complete
*OPT? –
OPTion
identification
query
*RST – ReSeT
*SRE – Service
Request Enable
*STB? – STatus
Byte query
*TST? – self
TeST query
*WAI – WAIt to
continue
Operating Manual 1505.3896.12 - 14
Parameters/
Short Description
Remarks
–
Sets the status byte (STB), the standard event register (ESR) and the
no query
EVENt part of the QUEStionable and the OPERation register to zero.
The command does not alter the mask and transition parts of the
registers. It clears the output buffer.
0 to 255
Sets the event status enable register to the value indicated. The query
*ESE? returns the contents of the event status enable register in
decimal form.
–
Returns the contents of the event status register in decimal form (0 to
query only
255) and subsequently sets the register to zero.
–
Queries the instrument identification string of the R&S OSP.
query only
–
Sets bit 0 in the event status register when all preceding commands
have been executed. This bit can be used to initiate a service request.
The query form writes a "1" into the output buffer as soon as all
preceding commands have been executed. This is used for command
synchronization.
–
Queries the options included in the instrument and returns a list of the
query only
options installed. The response consists of arbitrary ASCII response
data according to IEEE 488.2. The options are returned at fixed
positions in a comma-separated string. A zero is returned for options
that are not installed.
–
Sets the instrument parameters to values for good remote operation. All
no query
relays for the R&S OSP are set to their power up states and I/O output
channels are set to LOW state.
0 to 255
Sets the service request enable register to the value indicated. Bit 6
(MSS mask bit) remains 0. This command determines under which
conditions the MSS (master status summary) bit of the Status Register
is set. The query *SRE? returns the content of the service request
enable register in decimal form. Bit 6 is always 0.
–
Reads the contents of the status byte in decimal form.
query only
–
Initiates the selftest of the instrument and outputs an error code in
query only
decimal form (0 = no error)
–
Prevents servicing of the subsequent commands until all preceding
no query
commands have been executed and all signals have settled (see also
command synchronization and *OPC).
Remote Command Reference
152
Advertisement
Table of Contents
