Setting The R&S Osp With The R&S Emc32; Interlock Functionality With R&S Emc32 - R&S OSP Operating Manual

R&S OSP
allows to take over only the required paths from the R&S OSP into the EMC32
application:
Press the OK button to store the actual property settings in the EMC32.
Selecting the Cancel button leaves the dialog without saving.
8.1.3 Setting the R&S OSP with the R&S EMC32
If the R&S OSP is configured as a switching device within the EMC32 as described
above, the path setting is straight forward.
For a quick test, the tab Test is pressed. The following dialog allows to select and
switch the paths defined in the Properties of the R&S OSP.
Via the click box, the path to be switched is selected.
Pressing the Switch button will cause the path which is highlighted to be switched in
the R&S OSP.
The further use of the Switch Unit R&S OSP within the R&S EMC32 like the definition
of the device SignalPaths is done in the usual manner with the R&S EMC32 software.
There is no further description in this manual; please refer to the EMC32 manual for
detailed information.
8.1.4 Interlock Functionality with R&S EMC32
An interlock monitoring in an EMS system can be achieved either with the module
R&S OSP-B103 or R&S OSP-104. Each of these modules has the functionality of
verifying if a line of an input port is connected to +28 V (closed interlock) or not (open
Operating Manual 1505.3896.12 - 14
Applications
176