Table of Contents
Advertisement
R&S OSP
Now select the OSP-B102 dialog and set K1 and K2 to position 1. Do not forget to
select the K1 and K2 buttons.
Now start the path configuration as follows:
►
3.5.1.2 Defining the Path for PA2
According to the above example, for amplifier PA2 the following paths are required:
Signal path
Sig Gen to PA2 input
PA2 Fwd to Power Meter Ch A
PA2 Fwd to Power Meter Ch B
Start the OSP Panel and make sure not to take over any undesired relay setting.
Select therefore in the OSP Panel >Configure >Deselect all Switches.
After that, select the OSP-B101 dialog and set K11 to position NC and K12 to position
NO. Do not forget to select the K11 and K12 buttons.
Now select the OSP-B102 dialog and set K1 and K2 to position 2. Do not forget to
select the K1 and K2 buttons.
Now start the path configuration as follows:
Select >Path >Save Path ... in the OSP Panel.
The following dialog will appear:
Operating Manual 1505.3896.12 - 14
Select >Path >Save Path ... in the OSP Panel.
The following dialog will appear:
The upper data field shows the paths which are already stored in the R&S OSP.
Type in the path name "Path_PA1" and press the button "Save".
Required relay position
R&S OSP-B101 / K11- NC, K12-NO
R&S OSP-B102 / K1-2
R&S OSP-B102 / K2-2
Getting Started
65
Advertisement
Table of Contents
