Starting The R&S Osp130 - R&S OSP Operating Manual

R&S OSP
3.
With the password enabled, the R&S OSP GUI is started with VNC authentication.
For the password, see
In order to type in the correct commands, we recommend to copy and paste the
commands high-lighted in green fields above.
For copying (Windows OS) use CTRL+C, for pasting (using PuTTY) use the right
mouse key.
5.3.2 Starting the R&S OSP130
After power-on, the R&S OSP130 instrument is in ready state after about 30 seconds.
If the OSP is connected to a LAN network, the IP address is displayed after booting:
The display shown above disappears after some seconds and the start screen is
displayed with basic information on the equipment:
Operating Manual 1505.3896.12 - 14
Type in the following commands:
cp -f /etc/inetd.conf.ori /etc/inetd.conf
reboot
This is shown in the following dialog:
chapter 5.3.1.
Instrument Functions
112