Table of Contents
Advertisement
R&S OSP
Go from the Main menu to the Configuration menu.
If the number of switches to be included in a path is rather small, it is recommended to
deselect all switches. This is done by choosing "Deselect all switches".
If the number of switches is rather large, chose "Select all switches" instead. Pressing
the key OK will perform the related action.
Now go back to the Main menu, and from there select "Manual Switching". In the following
steps define all relay and output channel settings you want to include in the path
configuration by using the
using the
deselect the ones not required if you have started from a selected switches configuration.
A path configuration may consist out of several relays located on different R&S OSP
modules. Please note that the relay buttons in the corresponding dialogs must be
selected for all relays which should be taken over in the path configuration.
Perform the settings of the R&S OSP-B101 module as shown in the second
screenshot in
position.
Then go back to the Main menu using the
If no path has been saved so far, the list shown in the dialog only contains undefined
paths. By default, on an R&S OSP130 there are ten paths which can be defined
(Panel_path_00 till Panel_path_01).
Operating Manual 1505.3896.12 - 14
FUNCTION
key if you have started from a deselected switches configuration, or to
STATUS
chapter
5.3.4. This selects K11 to be in NO and K15 to be in NC
key. Don't forget to select these relays and channels
key, and select the Path Switching menu.
MENU
Instrument Functions
124
Advertisement
Table of Contents
