Addressing R&S Osp Modules - R&S OSP Operating Manual

R&S OSP
3.3.5 Addressing R&S OSP Modules
If the OSP Device is correctly registered (see previous chapter), all R&S OSP modules
available are displayed in the OSP Panel dialog. To control the R&S OSP modules,
the following ways are possible:
1.
2.
By double-clicking the required R&S OSP module, a window is opened which shows
all the setup functions available for the selected module. The title line of that window
also indicates the slot where this module is placed, or both slots if the module has
double width (see also
different R&S OSP modules.
R&S OSP module configuration
If modules are configured in the R&S OSP but no modules are detected by the OSP
Panel (indicated in blue), please check that the R&S OSP device is registered
correctly. Refer to
Operating Manual 1505.3896.12 - 14
Select the required module displayed in the left field of the OSP Panel dialog.
or
Select the diagram of the required module in the upper right field of the OSP
Panel dialog.
chapter
chapter 3.3.2
5.1.2). See the following chapters for the dialogs of the
to register the R&S OSP device.
Getting Started
43