Table of Contents
Advertisement
R&S OSP
If your computer is equipped with a firewall function, it may be necessary to allow the
firewall to unlock the EMC32. See
It is recommended to allow free access to Internet for the EMC32.
For information on the actual LAN address for the R&S OSP please refer to
3.1.
8.1.2 Defining the R&S OSP Properties in the R&S EMC32
Selecting the tab Properties opens the dialog to define the properties of the R&S OSP.
The OSP driver reads the actual paths from the instrument and allows to remove
paths.
The path names shown in the above dialog have to be defined for the R&S OSP prior
to the use with EMC32.
R&S OSP properties
The definition of the EMC32 properties for the R&S OSP require a path configuration;
the paths already must be predefined in the R&S OSP. See
configuration.
Pressing this button loads all paths defined in the R&S OSP to the EMC32 application
The path which is highlighted in the path name list will be deleted in the EMC32
application. The path is not deleted from the flash memory in the R&S OSP. This utility
Operating Manual 1505.3896.12 - 14
chapter 3.3.1
for an example.
Applications
chapter
chapter 3.4
for path
175
Advertisement
Table of Contents
