Table of Contents
Advertisement
2-42
INSTALLATION
Dial-up Networking and the Passcode
If You Have Forgotten Your Passcode
Remote Control Interface Programming
When you make a Windows Dial-up Networking connection, Windows will ask you
for your passcode. To allow the connection to occur, enter any passcode that you set
at the 8500S's front panel. Once your PC is connected to the 8500S, you will be able
to access the 8500S functionality corresponding to the security level of your pass-
code.
If you have not set a passcode, leave the Windows dialog box blank.
You can reset factory defaults and wipe out security passcodes (in case you forgot
your A
A
passcode).
LL
CCESS
A) Remove power from the 8500S.
B) While pressing both the Escape and Setup buttons, restore power.
The Restore Defaults screen appears.
C) To gain access to the 8500S, press the E
D) Reprogram passcodes as necessary; see To Create a Passcode on page 2-40.
The RESTORE DEFAULTS button (in the Restore Defaults screen) restores
all System Setup and Input/Output parameters to their factory default
settings. It also erases all passcodes. You should never need to use this
button in an existing installation, although it is a convenient way to
make the 8500S "factory fresh" if it is being installed in a different facil-
ity.
The RESTORE DEFAULTS button takes you to a screen that allows you to
keep or erase any user presets that exist in your unit.
[Skip this step if you do not wish to program the GPI (contact closure) remote con-
trol interface.]
1. Navigate to Setup > Next > N
2. Program one or more remote control interfaces.
A) Navigate to the desired Remote Interface button (1 through 8) by repeatedly
pressing the Next button.
B) Hold down the button while turning the knob to select the desired function
for the interface.
Use either button below the appropriate graphics; both work the same.
A
P
RASE
LL
& R
> R
ETWORK
EMOTE
EMOTE
ORBAN MODEL
soft button.
ASSCODES
.
I
NTERFACE
Advertisement
Table of Contents
Troubleshooting
