Orban OPTIMOD-FM 8500S Operating Manual page 107

OPTIMOD-FM DIGITAL
timeout does not apply.
•
This command is useful in interfacing automation systems to the 8500S.
2. To turn the analog diversity delay on or off for a given output:
Command
DE XXX[PASSCODE]
In the above table:
•
If a non-existent control value and/or an invalid passcode is entered, the 8500S
will ignore the command.
•
You can apply this command anytime after the 8500S boots up. The 30-minute
timeout does not apply.
3. To set the analog diversity delay:
Command
TR X.XXXXXXXXX[PASSCODE]
In the above table:
•
This command is useful when a station has two transmission chains (typically
main and backup) that require different diversity delay settings. We recommend
first using 8500S PC Remote to set the correct delays for the main and backup
chains. When you have found the correct delay for each transmission chain, write
down the delay times that PC Remote displays. Then program these into "main"
and "standby" batch files that, when executed, send the appropriate TR com-
Response
(valid passcode and argument)
DIVERSITY DELAY: [ON,OFF] (for each
output)
(invalid passcode)
[no error message is issued]
XXX = ANALOG_ON, ANALOG_OFF, DIGITAL1_ON,
DIGITAL1_OFF, DIGITAL2_ON, DIGITAL2_OFF,
COMPOSITE_ON, COMPOSITE_OFF, or ?
? returns the current on/off status for each output that is
configured to emit the analog FM processed audio
PASSCODE = ANY VALID PASSCODE.
Response
(valid passcode and argument)
DELAY: X.XXXXXXXXX
(invalid passcode)
[no error message is issued]
X.XXXXXXXXX = the delay time or ?. Acceptable values are
0.000015625 to 8.192 for the 8-second board and
0.000015625 to 16.384 for the 16-second board
(10 total digits) in increments of 0.000015625
? returns the current delay time.
PASSCODE = ANY VALID PASSCODE.
2-51
INSTALLATION