Built-In Calibrated Bypass Test Mode; Monitoring On Loudspeakers And Headphones - Orban OPTIMOD-FM 8500S Operating Manual

OPTIMOD-FM DIGITAL
driven equipment will undo the effect of the 8500S's internal de-emphasis, so the
8500S's output level should be adjusted such that the tone produces 100% modula-
tion of the transmission link as measured after the link's pre-emphasis filter. At
100Hz, switching the de-emphasis out or in will have negligible effect on the level
appearing at the 8500S's left and right audio outputs.
You can adjust the frequency and modulation level of the built-in line-up tone. You
can use the front panel, the PC Control software, or the opto-isolated remote con-
trol interface ports to activate the Test Tone.

Built-in Calibrated Bypass Test Mode

A BYPASS Test Mode is available to transparently pass line-up tones generated ear-
lier in the system. It will also pass program material, with no gain reduction or pro-
tection against overmodulation. It can transparently pass any line-up tone applied
to its input up to about 130% output modulation, at which point clipping may oc-
cur.

Monitoring on Loudspeakers and Headphones

In live operations, highly processed audio often causes a problem with the DJ or
presenter's headphones. The delay through the 8500S can be as much as 37 milli-
seconds (when S
distinct echo, which most talent finds uncomfortable and distracting. However, the
normal delay through the 8500S (from input to FM outputs) is about 18 ms when
H or M
ARD EDIUM
those with "LL" ("low latency") or "UL" ("ultra-low latency") in their names. An 18
ms delay is workable for most talent (although it may require some acclimatization)
because they do not hear echoes of their own voices in their headphones. Conse-
quently, users can ordinarily replace an older processor with the 8500S with no stu-
dio wiring changes. Moreover, off-air cueing of remote talent is routine.
Two lower-delay options are available. "Low latency" reduces input / FM-output de-
lay to 13 ms and "ultra-low latency" reduces delay to about 3.7 ms. The trade-off for
this reduction is approximately 1 dB decrease in loudness compared to the 8500S's
full look-ahead processing for low latency and about 2.5 dB loudness decrease for
ultra-low latency.
•
You can invoke the low latency mode by setting the B
the C
LIPPERS
"LL" as part of its name.
LLH
ARD
per:
•
LLH
is functionally equivalent to setting the L
cept that it reduces input/output delay by 5 ms).
bass clipping is selected). This delay is likely to be audible as a
OFT
bass clipping is selected, as it is in all factory presets other than
page of A
C
DVANCED
ONTROL
differs in two ways from the normal H
automatically defeats the compressor lookahead. (This action
ARD
C
ASS
) to LLH or by recalling a preset with
,
ARD
mode of the bass clip-
ARD
control to O
OOKAHEAD
INTRODUCTION
control (in
M
LIP ODE
, ex-
UT
1-25